Skip to search boxSkip to navigationSkip to main content

Effect of photoinitiator level on properties of a light-cured and post-cure heated model resin system.

*Corresponding author for this work
Scholary Output:
Contribution to journal
Article
Peer-review

Abstract

OBJECTIVES: This study evaluated the effect of increased levels of photoinitiator components on biaxial flexural strength, monomer conversion, and dynamic thermal properties of an unfilled model resin system in both the light-cured only state as well as after post-cure heating. METHODS: Unfilled polymer discs were made using 50/50 mole% Bis-GMA and TEGDMA and were rendered photo-curable using a common (normal) concentration of photoinitiators (camphorquinone 0.3 wt% and DMAEMA 0.75 wt%) as well as twice and four-fold this amount. Specimens were light-cured and left unheated or were post-cure heated in a commercial unit. Biaxial flexural strength was obtained at a constant stressing rate (100 MPa/s), monomer conversion was determined using FTIR, and dynamic mechanical thermal properties (E', E", and Tg) were measured with DMA. Data were analyzed using ANOVA and Turkey-Kramer post-hoc test (p < 0.05). RESULTS: Increased levels of photoinitiator above normal significantly increased monomer conversion and Tg values for unheated as well as for post-cure heated specimens. Biaxial flexural strength for light-cured only groups remained unaffected by change in initiator concentration, but was significantly increased by post-cure heating. Increase in initiator concentration did not affect E' values for post-cured specimens, but significantly increased values for the unheated, light-cured only groups. E" values for post-cure heated specimens were significantly lowered by increasing initiator concentration. SIGNIFICANCE: The clinical implications of these results indicate that increasing photoinitiator levels results in post-cure heated restorations with significantly higher Tg and monomer conversion values. Use of elevated initiator concentrations for post-cured resins could result in restorations with enhanced resistance to deformation at elevated oral temperatures as well as significantly lower amounts of leachable components.

Publication Information

Output type

Scholary Output:
Contribution to journal
Article
Peer-review

Original language

English (US)

Pages from-to (Number of pages)

Pages 360-364 (5 pages)

Journal (Volume, Issue Number)

Dental materials : official publication of the Academy of Dental Materials (Volume 13, Issue 6)

Publication milestones

  • Published - 11/1997

Publication status

Published - 11/1997

ISSN

0109-5641

Publication IDs

  • Scopus: 0031282687
  • PubMed: 9823097
  • ORCID: /0000-0003-1947-3337/work/54796671

Publication metrics

Metrics

Scopus
citations
SciVal
FWCI
2.27
SciVal
Author count
3
SciVal
citations
68
SciVal
Paper percentile
91
SciVal
Top percentile
10
Fractional count
1
Fractional count
0.33
Fractional count
2
Fractional count
0.67
Fractional count
1
Fractional count
1

PlumX, opens in new tab

Captures
51
Citation count
78

Funding Details

FunderFunding number
NIDCR
R29DE009418